The EP Greenhouse gear driver is a concise and lightweight reduction gear driver with a built-in limit switch system that is ideal for assembly of a locally available electric engine. The geared motor can be used in manually-managed or climate-controlled ventilation and display screen systems in greenhouses. The quick and easy-to-install EP gear driver is rainproof and 
windproof. The geared motor includes a high protection course (IP65) and can be used in an ambient temperature of 0-60 °C.
The low-noise geared motor for Greenhouse has a gearwheel transmission and a worm wheel transmission, which are integrated in an aluminum precision housing. The self-braking worm wheel transmitting ensures that the drive shaft is certainly locked when the reduction reducer is not running. The completely sealed reduction gear driver comes with an expansion chamber with a diaphragm to keep carefully the gear oil at a minimal pressure under all circumstances, even at high temperatures. Thanks to the use of an expansion chamber, the reducer can be installed in any position. There are no restrictions, because there is no dependence on a bleed connect. The sealed reduction gearbox keeps the gear oil of the geared motor in ideal condition because of its entire operating lifetime. The geared motor is ideal for discontinuous use, working course s3-30%, with a maximum activation time of 25 minutes.
The Gear box reduction reducer comes with an FT85 motor assembly flange, on to which a suitable IEC standard motor can certainly be installed (EN 50347).
The Gear box includes a rotating limit switch system with operating switches and circuit breakers (NC contacts) for turning off at the end positions. The limit change system is installed in an included chamber and is usually enclosed by an impact-resistant plastic-type material cover. The limit switch system is accessible and easy to adjust. The limit change system’s maximum switching range is 40 or 64 revolutions of the drive shaft. The cabling is linked in spring-clip connections. The gear motor has an IP68 M16 x 1.5 cable gland (5-9 mm cable) for the cable feed-through.
The geared motor for greenhouse comes with 16 teeth 5/8”x3/8” sprockets, keys and fasteners. The accompanying chain couplings and assembly plates can be found as accessories.
Optimum drive torque of 150 Nm or 450 Nm.
Rotational speeds of 3 or 5 rpm for a mains frequency of 50 Hz or 3.6 or 6 rpm for a mains frequency of 60 Hz in case of software of 4-pole electric motor.
Protection class IP65.
May be used in ambient temperatures of 0-60°C.
Ideal for discontinuous use, operating class s3-30%, maximum activation time 25 mins.
Equipped as standard with 16-tooth galvanised chain coupling 5/8″x3/8″.
FT85 motor assembly flange for installation of IEC standard motor (EN 50347).
Maximum switching range of limit switch program 40 or 64 revolutions of the drive shaft.
IP68 M16x1.5 cable gland for cable feedthrough (5-9 mm cable).