one.A connecting hyperlink of an O-ring Chain for general application is pre-coated with grease with the pins. In advance of connection, verify the grease over the surfaces of pins, and if your level of grease is smaller, apply grease with bare hands. (If gloves are utilized, the grease might be absorbed from the gloves.)
Illustration: Once the connecting website link (I) of an O-ring chain for standard application is
shipped, O-rings are fitted in the roots with the pins. In the event the O-rings come loose due to vibration during transport, refit the O-rings in to your roots from the pins.
In this case, you should definitely return the grease collected at the roots from the pins to your central surfaces of your pins, additional at portion A than at portions B shown during the above illustration. (Portions A is worn on account of sliding together with the bushings.)
two.The chain is usually most simply linked around the teeth of the sprocket. Engage the back links at the two ends from the chain with the sprocket teeth and match connecting pins. Should the sprocket could be moved, the chain may also be connected to the loosened side.
three. Connecting procedure
1.Verify that O-rings are connected to your roots with the pins.
2.In case the volume of grease applied to the connecting pins is modest, coat the pins with grease in the central portions.
3.Insert the connecting pins into the bushings from the inner links at both ends.
4.Verify that the grease is utilized to your total face from the O-ring, and fit the O-ring onto the connecting pins.
5.Insert the connecting pins in to the connecting plate and though pressing the connecting plate, set up the spring clip. Confirm whether the head (the end with no split) of the spring clip is turned in the feeding path on the chain. (See the following illustration.)
6.Be sure to verify that the spring clip is securely fitted from the clip grooves with the connecting pins.
This completes jointing from the connecting website link. Note that grease around the surfaces of connecting pins and O-rings is usually removed for the duration of installation function. In this case, re-grease making use of the grease within the surface of your base chain or the grease from the polyethylene bag during which the connecting hyperlink was contained.