Electrical power UNITS FOR LIFT TABLE 1
Basic Description
This energy unit is designed exclusively to the small lift table,Consisting of higher pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This electrical power unit continues to be broadly used during the market of logistic devices including minifork lift, scissors lift and ariel working platforms. The lower-ing movement is controlled from the solenoid valve with all the velocity controlled from the adjustable needle valve.
Energy UNITS FOR LIFT TABLE two
General Description
This electrical power unit is made solely for the medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion is actived from the solenoid valve and also the speed controlled by the adjustable needle valve. When the lift rises to a substantial positoin, but the power provide is cut, the lowering movement is controlled by the manual override function.
Power UNITS FOR LIFT TABLE three
Basic Description
This power unit is designed exclusively for the large lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve as well as velocity controlled by a stress compensated movement manage valve.
Electrical power UNITS FOR LIFT TABLE 4
Standard Description
This power unit is created exclusively for the large lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived from the solenoid valve plus the velocity managed through the adjustable needle valve. When the lift rises to a higher positoin, but the electrical power provide is minimize, the reducing motion is managed through the manual override perform.
Distinctive Notes
1. This electrical power unit is of S3 duty cycle, which might only perform intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean each of the hydraulic components concerned before installation of the electrical power unit.
3. Viscosity of the oil shoud be 15~46 cst,which must also be clean and free of charge of impurities.N46 hydraulic oil is advised.
4. Oil transforming is required just after the first one hundred operation hours,afterwards after each and every 3000 hours.
five. The electrical power unit proven is created to be mounted vertically.